Publicité
Step 3
NOTE: Stand the UPRIGHT (D2) in place to be sure you
å
are drilling through the correct holes in the TOP (E2).
There are four pre-drilled holes in the top surface of the
å
TOP (E2). Finish drilling out two holes with your electric
drill and 1/4" drill bit.
Fasten the UPRIGHT (D2) to the TOP (E2). Use two
å
BLACK 1-15/16" FLAT HEAD SCREWS (113S).
Fasten the UPRIGHT (D2) to the LARGE SHELF (I).
å
Tighten two TWIST-LOCK® FASTENERS.
BLACK 1-15/16" FLAT HEAD SCREW
www.sauder.com/services
113S
(2 used in this step)
I
Find the correct pre-driled holes that
line up with the UPRIGHT (D2) and drill
through the top surface of the TOP (E2).
E2
D2
422427
LARGE DOOR ON LEFT
This locator hole
must be here.
These four holes must be here.
Page 9
Publicité
