Publicité
Step 24
Step
Slide the FEET (31E and 32E) into the notches in the SKIRTS (Q and R).
å
Use a hammer to drive a PROPEL NUT (14M) into the holes in the
å
FEET (31E and 32E). Now, turn an ADJUSTABLE GLIDE (18E) into each
PROPEL NUT as shown in the upper diagram.
Fasten the SKIRTS (Q and R) to the BOTTOM (F2). Use four
å
BLACK 9/16" WAFER HEAD SCREWS (33S) through
the FEET and into the BOTTOM as shown
in the lower diagram.
NOTE: You should start each SCREW a few
å
turns before completely tightening
any of them.
Page 30
18E
(4 used)
14M
Q
32E
This hole must be here.
31E
R
F2
R
422427
LARGE DOOR ON RIGHT
32E
31E
R
R
Q
BLACK 9/16" WAFER HEAD SCREW
(4 used for the FEET)
www.sauder.com/services
33S
Publicité
