Publicité
Step 8
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (K) and lay it over your unit.
Make equal margins along all four edges of the BACK (K). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (K) to your unit using the NAILS (1N).
å
Fasten the FOOT BASES (24E) to the BOTTOM (F2). Use eight
å
SILVER 5/8" FLAT HEAD SCREWS (23S). Then, push the
FEET (25E) into the FOOT BASES (24E).
NOTE: Turn the adjustable ends of the ADJUSTABLE FEET
å
completely in. Final adjustments will be made after the unit is
standing upright.
Fasten the METAL BRACKET (4G) to the BOTTOM (F2)
å
and FRONT SKIRT (Q). Use two BLACK 9/16" LARGE
HEAD SCREW (1S).
SILVER 5/8" FLAT HEAD SCREW
(8 used for the FOOT BASE)
25E
Turn completely in.
These holes must be here.
Page 14
23S
NAIL
(72 used for the BACK)
24E
F2
Q
4G
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1N
K
BLACK 9/16" LARGE HEAD SCREW
(2 used for the ANGLE BRACKET)
422427
LARGE DOOR ON LEFT
These holes must
line up over the
UPRIGHT (D2).
60M
Before fastening
the BACK, push the
SAFETY STRAP
through the hole.
1S
www.sauder.com/services
Publicité
