Publicité
Step 20
Step
NOTE: Stand the UPRIGHT (D2) in place to be sure you
å
are drilling through the correct holes in the TOP (E2).
There are four pre-drilled holes in the top surface of the
å
TOP (E2). Finish drilling out two holes with your electric
drill and 1/4" drill bit.
Fasten the UPRIGHT (D2) to the TOP (E2). Use two
å
BLACK 1-15/16" FLAT HEAD SCREWS (113S).
Fasten the UPRIGHT (D2) to the LARGE SHELF (I).
å
Tighten two TWIST-LOCK® FASTENERS.
Find the correct pre-driled holes that
line up with the UPRIGHT (D2) and drill
through the top surface of the TOP (E2).
This locator hole
must be here.
These four holes must be here.
Page 26
E2
D2
422427
LARGE DOOR ON RIGHT
113S
BLACK 1-15/16" FLAT HEAD SCREW
(2 used in this step)
I
www.sauder.com/services
Publicité
