Publicité
Step 13
Carefully stand your unit upright and position in its fi nal location.
å
NOTE: To lift a corner of the unit, rotate the ADJUSTABLE GLIDE to the left.
å
To lower a corner, turn the ADJUSTABLE GLIDE to the right.
Turn the ADJUSTABLE FEET (25E) downward until they touch the fl oor.
å
IMPORTANT: The ADJUSTABLE FEET should not extend beyond the bottom
å
edges of the ADJUSTABLE GLIDES.
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the mounting screw.
Fasten the LARGE DOOR (L2) to the LARGE END (B2) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each SCREW a few
turns before completely tightening any of them.
Fasten a PULL (102K) to the LARGE DOOR (L2). Use two
å
SILVER 3/4" MACHINE SCREWS (20S).
See the next step for
å
DOOR adjustments.
L2
102K
www.sauder.com/services
B2
SILVER 3/4" MACHINE SCREW
(2 used for the PULL)
Turn the ADJUSTABLE FEET
R
downward until it touches the fl oor.
422427
LARGE DOOR ON LEFT
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
20S
Floor
25E
Page 19
Publicité
