CLAS PE 2002T Mode D'emploi page 70

PE 2002T PE 2006T
4.4.6.2 ALIGNMENT DURING THE OPERATION
During operation, the alignment of the carriages is automatically maintained by a hydraulic system
of serial connected jacks with a transfer circuit. It is however compulsory to always carry out the
alignment each time a slight difference in the height of the two carriages is noted.
In this case, press the «UP» push-button (22, Fig. 1) until both carriages reach their maximum
height. Keep pressed for a few seconds. (This manoeuvre can be carried out also during the
ordinary operation with a load on the lift, provided that the misalignment between the carriages
does not exceed 3-4 cm.). Then, proceed with the lowering manoeuvre.
WARNING: During this operation check that the misalignment of the carriages remains
constant.
DANGER: It is forbidden to use the lift in case the load-bearing arms are rapidly misaligned
after carrying out the align-ment of the carriages.
4.4.7 DECALS AND PICTOGRAMS APPLICATION
Attach the decals (if they are not yet applied by the manufacturer) supplied with this manual to
the lift in the positions shown in the diagram in Figure 6.
WARNING: failure to attach the decals will make the warranty null and void and the
manufacturer shall not be liable for any damage resulting from lift operation.
In the event one or more decals of the lift are damaged, or so deteriorated as to become
illegible or are lost, contact the seller or the manufacturer with the position number shown
in Fig. 6. Attach the new decals at the correct positions on the lift as soon as possible.
70
PE 2007T