CLAS PE 2002T Mode D'emploi page 65

PE 2002T PE 2006T
3.6 LIFT IDENTIFICATION AND PICTOGRAMS DESCRIPTION
The safety signals described in this manual are applied on the lift (fig. 6) and warn about unsafe
and hazardous situations. Decals shall be kept clean and, if detached or damaged, they shall be
immediately changed.
Carefully read the meaning of the safety signals, and memorise it:
Each lift is supplied with the identification plates (Fig.5) relating to the different versions. Data (A)
and (B) have always to be mentioned for any service and spare parts need.
WARNING: Once the assembly has been carried out, the operator should apply the
identification plate, according to the installed lift version, in its proper position (6, Fig. 6).
3.7 INTENDED USE
The vehicle lifts described in this manual are designed and manufactured for lifting vehicles for
inspection, maintenance and/or repair purposes only.
The vehicle lift must be used only for lifting vehicles within the load capacity limits given in the
IDENTIFICATION PLATE (Fig. 5) and in the paragraph 1.3 «LOAD DISTRIBUTION» (Fig. 3)
PE 2007T
1 plate CE
A Serial No.
B Model
Max. Load
C
D Ground
Manuf.year
E
F Voltage
Freq.
G
BEFORE USING THE LIFT, CAREFULLY READ THE INSTRUCTIONS
GIVEN IN THIS MANUAL
Power
H
I Pressure
L Absorption
65