Introduction - ITW Simco CMM Easy Notice D'utilisation

1 Introduction

The External Control Kit CMM Easy should be installed between the machine interface/power
supply of the customer and the CMM Easy charge generator. Among other things, the
Control Kit is used to control the output voltage of the generator. This can be done in three
different ways:
1) By using the control button on the Control Kit (Local). In this setting it is also possible to
limit the maximum output voltage.
2) Remotely, with an analogue voltage of 0-10 V DC.
3) Remotely, with an analogue voltage of 0-24 V DC.
By means of the LED indicator on the Control Kit the "Cycle OK" signal of the generator can be
seen. Using the supplied adhesive label the Control Kit can be secured on a machine panel.
Machine panel
LED indicator
(FRONT VIEW)
Fig. 1, External Control Kit CMM Easy
ExternalControlKit_CMMEasy_UM_9752098550_NL_D_GB_F_V2_0
Adhesive label
Setpoint limiter 9-18 kV max.
Control knob
Machine connector
Setpoint switch
Local/Remote
(BACK VIEW)
CMM Easy-connector
- Remote
Setpoint
- Local
Setpoint connector
34