Zanussi ZDK320 Notice D'utilisation page 12

Product description
Cooking surface layout
Electric cooking zones control knobs
Symbol
0
Operation
To switch on and increase the heat setting turn the knob
counterclockwise. To decrease the heat setting turn the
knob clockwise. To switch off turn the knob to the 0.
Power indicator is activated when either of the zones are
turned on, and will stay on until the cooking zones are
switched off.
Before first use
Put cookware containing water on each cooking zone, set
the maximum position and operate the appliance for 10
Helpful hints and tips
Cookware
• The bottom of the cookware must be as thick and
flat as possible.
• Cookware made of enamelled steel and with alu-
minium or copper bottoms can cause discolora-
tion on glass ceramic surface.
Energy saving
• If possible, always put the lids on the cookware.
• Put cookware on a cooking zone before you start
it.
12
1
180
mm
145 2
mm
3
4
Function
off position
1 Rear cooking zone 1700 W
2 Front cooking zone 1200 W
3 Power indicator
4 Control knobs
Symbol
1
6
min. This is to burn off the residue in the appliance. After
that, operate the appliance at minimum position for 20
min. During this period, an odour and smoke can occur.
This is normal. Make sure that the airflow is sufficient.
• Stop the cooking zones before the end of the
cooking time to use residual heat.
• The bottom of pans and cooking zones must
have the same dimension.
Use pots and pans with bottom applicable to the di-
mension of the cooking zones.
Cooking zone
Front
Rear
Function
minimum heat
maximum heat
Diameters of cookware
max. 145 mm
max. 180 mm