Publicité
Les langues disponibles
Les langues disponibles
5 - Putting into service-Temperature settings
- After waiting 48 hours, connect your cabinet to the mains socket after making sure it is correctly supplied (check fuses and amperage and circuit-brea-
ker). Connect another electrical device to check mains if necessary.
- Once your cabinet is plugged in, make sure the On-Off switch on the far right side of the control panel is in the "On" position ( I ).
- When you plug in your wine cabinet, must if the switch is in the "On" position (see diagram above), or if the desired temperature is less than the tempera-
ture in the room,the green light indicating that the refrigeration circuit is operating, go on
(unless your cabinet is a "Viellitheque" 1 temperature model and is placed in a room
or if the desired temperature is less than the temperature in the room,
whose temperature is below 12 ¡C (54¡F)).
NOTE: In case of operating problems, refer to section 9 of this guide.
- 6 -
Publicité
