Publicité
Les langues disponibles
Les langues disponibles
6- L
IV - Modification to cabinet layout
To change the position of a storage shelf, first of all completely unload the shelf, and move the
shelf supports taking care to re-attach them as shown opposite:
To change the position of a sliding shelf, first of all completely unload the shelf. Then lift the sliding shelf and slid it towards you whilst holding the front of
it upwards. Remove the wall slider guides, marking which is right and which is left, then reinstall them as shown below:
W all
Guide
W all
Guide
Then replace the sliding shelf as shown opposite:
7 - C
1- Connection
Check that the plug is connected to a power supply (presence of correct amp fuses, functioning
30 mA* differential circuit breaker (*not applicable to certain countries).
Make sure you wait 48H before commissioning.
I1- Switching on
Press the on/off button located on the control panel on the left hand side
10
– S
AYO UT
Installing the rear section
of the guide
Sliding shelf
Guide
O MMISSIO N IN G YO UR W IN E CABIN ET
TO RAGE
Installing the front section
of the guide
Guide
Shelf
support
W all
Guide
W all
W all
Publicité
