Eurocave Premiere Serie Mode D'emploi page 48

5 - I
II - D oor reversibility
a - Parts summar y
1 - 2: grommets
3:Torx screws 25
4: upper hinge
5: spacer
6: lower hinge
7: lock receiver
b - D oor reversibility
Your wine cabinet door is reversible. In this way you can change
which way it opens.
• Close the door
• Remove the grommets, see Fig.A.
• Remove the torx screws and the upper hinge.
• Lift and take off the door and put it to one side
• Carefully set down your wine cabinet onto its side. (The side
where the flexible cable is attached).
• Remove the screws, lower hinge and spacer, see Fig.B.
• Fit on the opposite side: the spacer and the lower hinge using the
torx screws, see Fig. C , and position it according to the guidelines
Fig.D
• Stand the cabinet upright.
• D ismantle the lock receiver by removing the screws, see Fig.E
• Reassemble the lock receiver on the opposite side.
• Position the door onto the pin of the lower hinge. H old the door
against the door seal.
• Place the pin of the upper hinge in the corresponding slot of the
door.
• Fit the 3 screws. Ensure that the hinge is fixed properly into place,
if not adjust it. See Fig.F .
• Fit the 3 grommets.
• W ait 48 hours before plugging in
Fig.D
8
N STALLIN G YO UR W IN E C ABIN ET
Fig.E
2
7
Fig.A
Fig.B
1
5
3
4
Fig.C
Fig.F
6