Publicité
Les langues disponibles
Les langues disponibles
Origine_notice_2-GB.qxd
13/02/07
7 - C
V - Changing the remote control batteries
The lifespan of the LR03/AAA batteries in the remote control is estimated to be between 8 to 12
months depending on usage.
A warning light
on the remote control's display will tell you that the batteries (2x LR03/AAA)
need replacing as quickly as possible.
1 - Open the battery compartment cover on the back of the remote control.
2 - Insert the batteries ensuring correct polarity.
3 - Close the flap and your remote control is once more ready to use.
Your wine cabinet will continue to operate normally even when the remote control's batteries are
discharged. When the batteries have been replaced, the remote control will automatically reset itself
to the previous configuration.
In the event of a power failure, your wine cabinet will switch off. If this happens, keep the wine
cabinet's door closed and avoid opening at all costs. The system will re-boot once the power supply is re-established.
VI - Adding a second remote control for the same wine cabinet
Set up the second remote control as follows
If you wish, you can have an additional remote control for your wine cabinet, for that disconnect the cabinet and then reconnect it a few seconds.
The cabinet will also recognise your additional remote control.
Press on the
and
Select °C/°F using the
In the event that you have several Origine cabinets, select the number of the wine cabinet, then press on
Select the number of the display AFF = 2 (Second display). Press and hold down the
The Prg + symbol display
Caution: A second display cannot be re- allocated in the same way as the original on the same wine cabinet.
VII - Setting the wine cabinet Number
If you have several models of this wine cabinet, each remote control is allocated to a specific wine cabinet.
To make it easier to identify the remote controls, allocate each wine cabinet a number and enter it into the remote control program menu as follows:
Press on the
and
Select °C/°F using the
In the event that you have several Origine cabinets, select the allocated number of the wine cabinet, then press on
Select the number of the display AFF = 2 (Second display). Press and hold down the
The Prg + symbol display appears
If you have only one Origine cabinet, you can allocate the wine cabinet number as 0, in which case no number will appear on the screen
in temperature display mode.
12:13
Page 13
OMMISSIONING YOUR WINE CABINET
keys simultaneously for several seconds.
and
a keys.Then press on
appears whilst the data is being transferred to the wine cabinet.
keys simultaneously for several seconds.
and
a keys.Then press on
whilst the data is being transferred to the wine cabinet.
.
key.
.
key.
to confirm.
to confirm.
13
EN
Publicité
