Eurocave Origine Serie Mode D'emploi page 28

Origine_notice_2-GB.qxd 13/02/07
6- L
IV - Modification to cabinet layout
To change the position of a storage shelf, first of all completely unload the shelf, and remove the
shelf supports taking care to re-attach them as shown opposite:
To change the position of a sliding shelf, first of all completely unload the shelf. Then lift the sliding shelf and slid it towards you whilst holding the front of
it upwards. Remove the wall slider guides, marking which is right and which is left, then reinstall them as shown below:
Wall
Guide
Wall
Guide
Then replace the sliding shelf as shown opposite:
7 - C
1- Connection
Check that the plug is connected to a power supply (presence of correct amp fuses, functioning 30 mA*
differential circuit breaker (*not applicable to certain countries).
Make sure you wait 48H before commissioning.
Connect your wine cabinet to the mains power supply.
Open the battery cover on the back of the remote control and insert the batteries ensuring that the polarity
is correct. You will see "INIT" on the display.
After a few moments the temperature will be displayed on the remote control screen.
Press on the and
Select °C/°F using the
In the event that you have several Origine cabinets, select the allocated number of the wine cabinet, then press
on to confirm.
Select the number of the display AFF = 2 (Second display). Press and hold down the
The Prg + symbol display appears
If you have purchased several wine cabinets, install them one after another, making sure you carefully follow each
10 one's installation stages.
12:13 Page 10
– S
AYOUT TORAGE
Installing the rear
section of the guide
Sliding shelf
Guide
OMMISSIONING YOUR WINE CABINET
keys simultaneously for several seconds.
and a keys.Then press on
whilst the data is being transferred to the wine cabinet.
Shelf
support
Installing the front
section of the guide
Guide
.
key.
Wall
Guide
Wall