Publicité
Les langues disponibles
Les langues disponibles
Origine_notice_2-GB.qxd
13/02/07
8 - E
Your EuroCave wine cabinet is a tried and tested, easy-to-use appliance. The following few maintenance
operations will enable your cabinet to provide you with many years of faithful service.
- Each year, you should replace the active carbon filter located in the upper breather hole of your cabinet.
Manually remove the carbon filter (see diagram opposite). You can obtain a replacement carbon filter from
your usual retailer. The replacement part should have an original manufacturer's guarantee.
- Clean and dust the condenser (metal grid located the length of the rear wall of the cabinet) twice a year.
- When cleaning the back of the cabinet, and before moving it, make sure it has been disconnected from the
mains power supply and that there are no bottles left in the cabinet.
- Once a year completely clean the interior of your cabinet after emptying it and ensuring it disconnected
from the power supply (use water and a non abrasive cleaning product, then rinse carefully).
Check the appliance regularly and, if you suspect that something is not functioning correctly, notify your retailer.
This possible anomaly, is the best way to ensure that your wine cabinet will provide you with long and faithful
service.
9 - T
In all cases, if your cabinet does not appear to be operating correctly contact your EuroCave wine cabinet retailer.
Any intervention on the refrigeration unit must be carried out by a qualified
refrigeration technician who will check the circuit is fully sealed before powering up. In
the same way, any intervention on the electrical circuit should be carried out by a qualified
electrician.
- If
is flashing, you have moved out of signal range and need to be closer to the wine cabinet.
Press either on
and
- If the display is faulty, re-boot the remote control. To do this, remove the batteries from the remote control. Disconnect your wine cabinet from the power
supply. Re-install batteries in your remote control, ensuring correct polarity, and then re-connect the wine cabinet to the power supply. After a few moments
the temperature will be displayed on the remote control screen.
- In the event that the temperature measurement sensor is faulty, the display alternates between 0.0°C and --, and displays
- If your remote control displays temperature that does not correspond to the one you have set: this can be due to an overload of bottles in the wine cabinet
or the set temperature having been modified significantly. It can take several hours for your wine cabinet to stabilise and display the desired temperature..
If such a variation continues, check that the wine cabinet door is fully closed and that the door's leak proof seal is correctly seated..
Use of a glass door can change your wine cabinet's performance in certain extreme
temperature conditions.
14
12:13
Page 14
VERYDAY MAINTENANCE
ROUBLESHOOTING
to check the distance of your remote control's signal.
.
Publicité
