Toro Recycler 22in Manuel De L'opérateur page 16

6. After draining out the used oil, return the machine to
the operating position.
7. Pour about 3/4 of the crankcase capacity of oil in the
crankcase.
Note: Max. fill: 20 oz. (0.59 l), type: SAE 30 or SAE
10W-30 detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher.
8. Wait about 3 minutes for the oil to settle in the
crankcase.
9. Wipe the dipstick clean with a clean cloth.
10. Insert the dipstick into the oil-fill tube but do not
screw it in, then remove the dipstick.
11. Read the oil level on the dipstick (Figure 26).
•
If the oil level on the dipstick is too low, slowly
pour a small amount of oil into the oil-fill tube,
wait 3 minutes, and repeat steps 9 through 11 until
the oil level on the dipstick is at the correct level.
•
If the oil level on the dipstick is too high, drain the
excess oil until the oil level on the dipstick is at the
correct level.
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
12. Install the dipstick securely.
13. Recycle the used oil properly.
Adjusting the Self-propel Drive
Cable
Whenever you install a new self-propel cable or if the
self-propel drive is out of adjustment, adjust the self-propel
drive cable.
1. Loosen the cable support nut (Figure 28).
This figure is simplified for the purpose of clarity.
2. Pull down the cable jacket (toward the machine) until
there is no slack in the cable (Figure 29).
Figure 28
This figure is simplified for the purpose of clarity.
3. Tighten the nut on the cable support.
Replacing the Blade
Service Interval: Yearly—Replace the blade or have it
sharpened (more frequently if the edge
dulls quickly).
Important: You will need a torque wrench to install the
blade properly . If you do not have a torque wrench or
are uncomfortable performing this procedure, contact
an Authorized Service Dealer.
Examine the blade whenever you run out of gasoline. If the
blade is damaged or cracked, replace it immediately. If the
blade edge is dull or nicked, have it sharpened and balanced,
or replace it.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Disconnect the spark plug wire from the spark plug.
Refer to Preparing for Maintenance (page 14).
2. Tip the machine onto its side with the air filter up.
3. Remove the 2 blade nuts and the stiffener (Figure 30).
16
Figure 29