Toro Recycler 22in Manuel De L'opérateur page 11

5. Stop the engine and wait for all moving parts to stop.
Not Using the Grass Bag
1. Move the machine onto a paved surface in a non-windy
area.
2. Set all 4 wheels to the 3-1/4 inch (83 mm) cut setting.
3. Take a half sheet of newspaper and crumple it into a
ball small enough to go under the machine housing
(about 3 inches or 76 mm in diameter).
4. Place the newspaper ball about 5 inches (13 cm) in
front of the machine.
5. Start the engine.
6. Engage the blade.
7. Release the blade control bar.
8. Immediately push the machine over the newspaper ball.
9. Stop the engine and wait for all moving parts to stop.
10. Go to the front of the machine and check the
newspaper ball.
Note: If the newspaper ball did not go under the
machine, repeat steps 4 through 10.
11. If the newspaper is unravelled or shredded, the blade
did not stop properly, which could result in an unsafe
operating condition. Contact an Authorized Service
Dealer.
Recycling the Clippings
Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position,
move the lever to the recycling position; refer to
Operating the Bag-on-Demand Lever (page 12) before
recycling the clippings. If the side-discharge
chute is on the machine, remove it; refer to
Removing the Side-discharge Chute (page 13) before
recycling the clippings.
Bagging the Clippings
Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
Note: Ensure the bag is seated in the correct position.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side-discharge chute is on the machine, remove it;
refer to Removing the Side-discharge Chute (page 13) before
bagging the clippings. If the bag-on-demand lever is in the
recycling position, move it to the bagging position (refer to
Operating the Bag-on-Demand Lever).
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
Installing the Grass Bag
1. Raise and hold up the rear deflector (Figure 20).
1
1. Notches
2. Rear deflector
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle (Figure 20).
3. Lower the rear deflector.
11
2
3
G017305
Figure 20
3. Grass-bag pin (2)