TechniSat DIGITRADIO 586 Notice D'utilisation page 63

12.8 Signal strength
> Press the INFO button several times until the signal strength is displayed.
> The level of the bar indicates the current signal strength.
Stations with a signal strength below the required minimum signal intensity
are not transmitting a strong enough signal. If required, align the antenna as
described in section 7.3.1.
By pressing the INFO button several times, different information can be
scrolled through, such as station type, multiplex name, frequency, signal error
rate, data bit rate, station format, date (depending on the active source).
12.9 Dynamic Label Plus
If supported by the programme provider, the Dynamic Label Plus service also allows,
for example, the name of the current programme or the track and artist to be
displayed.
12.10 Setting DRC
The compression rate balances dynamic fluctuations and thereby any volume
variations that occur.
> Press the MENU button and select > [Volume Adjustment], to select the
desired compression rate.
> Use  or 
DRC high
DRC low
DRC off
> Confirm by pressing OK.
12.11 Deleting inactive stations
> Press the MENU button and use  or  to select > [Delete inactive
stations].
> Confirm by pressing OK.
> Using  or , select > [Yes] and confirm by pressing OK.
Minimum signal intensity
to select the compression rate:
- high compression
- low compression
- compression switched off.
Signal intensity
DE
EN
FR
NL
63