Zanussi ZRB634S Mode D'emploi page 49

Technical data
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/24h)
(kWh/year)
Energy class, according to EU standards
Freezing capacity (kg/24h)
Rising time (h)
Rated current (A)
Weight (kg)
Number of compressors
Installing the appliance
Transportation, unpacking
It is recommended to deliver the appliance in orig-
inal packaging, in vertical position considering the
protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.
Cleaning
Remove every adhesive tape and everything else, which
ensure the accessories not to move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
Placement
The ambient temperature has an effect on the energy
consumption and proper operation of the appliance.
When placing, take into consideration that it is practical
to operate the appliance between ambient temperature
limits according to the climate class that is given in the
chart below and can be found in the data label.
Class of climate
SN
N
ST
Ins tr uctions f
Ins tr uctions f
ZRB634S
Freezer:
Refrigerator: 110
Freezer:
Refrigerator: 92
1750
0,929
Ambient temperature
+10 ... +32 °C
+16 ... +32 °C
+18 ... +38 °C
or the Ins
or the Ins
226
223
595
632
339
A
4
20
1,1
38
66
1
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
breakdown in the automatic defrosting increasing temper-
ature in the cooling compartment or increasing energy
consumption.
In the bag of the accessories there are two spacers
which must be fitted in the two top corners.
Slacken the screws and insert the spacer under the screw
head, the re-tighten the screws.
t aller
t aller
G G B B
49