Télécharger Imprimer la page

Zanussi ZRB634S Mode D'emploi page 47

Réfrigérateur/ congélateur

Publicité

Les langues disponibles

Les langues disponibles

Regular cleaning
It is recommended to wash the inside of the refrigerator
in 3-4 weeks time using lukewarm water then wipe it (it is
practical to clean the inside of the freezer and defrost it at
a time).
Household cleaner or soap must not be used.
After breaking the circuit wash the appliance with lukewarm
water then wipe it. Clean the door gasket with clean water.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt collected on
the back of the refrigerator and the condenser and to clean
the evaporative tray on top of the compressor once or twice
a year.
When the refrigerator is not in use
In case the appliance will not be used for a long time fol-
low these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the screw holding the cover (1), press the rear
hook (2) and at the same time slide the cover in the direc-
tion indicated by arrow (3). So the bulb can be replaced.
(Bulb type: 230-240 V, 15 W, E 14 thread)
After changing the bulb replace the cover, snap it in place,
screw back the screw and apply voltage to the appliance.
If something does not work
During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, this goes together with the operation
of the appliance.
We draw it to your attention again that the appli-
ance operates discontinuously, so the stopping of
compressor does not mean being no-current. That is why
you must not touch the electrical parts of the appliance
before breaking the circuit.
G G B B
47

Publicité

loading