Exchanging The Safety Catch Set - pewag levo hook LH Manuel D'utilisation Original

9.3 Exchanging the safety catch set

EN
If parts of the safety catch set are missing or defect,
(e.g. broken spring), you may replace them as follows:
2
Fg. 16
4
Fg. 17
Fg. 18
Fg. 19
pewag levo hook LH
36
1
5
7
Fold the safety catch
swivel hook and loosen the safety screw
as shown in fig. 16. Slide out the axle.
safety catch 1
the spring.
When assembling the set, follow these steps in reverse order,
paying particular attention to the following points:
• When inserting the spring
spring leg running parallel to the axial direction
inserted into the drill hole on the inside of the safety latch
(fig. 18).
• The other spring leg, i.e. the one running transversal to the
axial direction
hook (fig. 19).
• Use a small amount of threadlock for the safety screw
Loctite type 243)
3
After assembly, always check that the safety catch is movable
and springs back into a vertical position on its own accord from
both directions. If this is not the case, it is likely that spring leg
was not inserted into the hook drill hole
6
catch to pieces and re-assemble correctly
9.4 Austausch Gegenstück
Sicherungsfalle
6
Fg. 20
Please note that the safety catch counter piece may only
be exchanged if your pewag levo hook was NOT fitted with
the optional magnetic module. If your pewag levo hook has
been fitted with the magnetic module, please refer to an
authorised pewag service provider.
To exchange the safety catch counter piece,
remove both screws
off the counter piece
follow these steps in reverse order. Use a small amount of
medium-strength threadlock for the screws (e.g. Loctite type
243) Always check whether the safety catch rests properly on
the support of the counter piece.
1 down fully towards the inner part of the
2 using an Allen key
3 You can now pull the
incl. spring 4 out of the hook (fig. 17). Remove
4 in the safety latch
6 , must be inserted in the drill hole
7
1
1 with a torx wrench (size TX 30) and pull
2 (fig. 20). To re-fit the counter piece,
1
, the
5 must be
7 in the
2 (e.g.
. Take the safety
2