Accessories; Environmental Protection; Technical Specifications - Metabo KSAP 18 Mode D'emploi

flange (21) and the saw blade fixing screw (20) must
be clean.
Put on the outer saw blade flange. Tighten the saw
blade fixing screw.
Do not use any saw blades which have a
thicker base body or a smaller width cut than
the splitting wedge.
Do not use any saw blades made from high-
alloy high-speed steel (HSS).
Do not use any saw blades which do not
conform to the specified rating.
f

9 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Guide rail
B 2 clamp clips. To secure the guide rail.
C Angle guide. To be placed against the guide
rail. Allows mitre cuts up to 45° on both sides.
D Circular saw blades. For wood and similar
materials. Medium cutting quality.
E Circular saw blades. For wood and similar
materials. Also suitable for coated boards.
Clean cut.
F Battery pack
G Chargers
10 Repairs
Repairs to electrical tools must be
carried out by qualified electricians
ONLY!
Any Metabo power tool in need of repair can be sent
to one of the addresses listed in the spare parts list.
Please enclose a description of the fault with the
power tool.

11 Environmental Protection

Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that can
be recycled.
These instructions are printed on chlorine-free
bleached paper.
Battery packs must not be disposed of with regular
waste! Please return faulty or used battery packs to
your Metabo dealer!
Do not throw battery packs into water.
Only for EU countries: Do not dispose of
electric tools together with household waste
material! In observance of European Direc-
tive 2002/96/EC on waste electrical and electronic
equipment and its implementation in accordance
with national law, electric tools that have reached
the end of their life must be collected separately and
returned to an environmentally compatible recycling
facility.

12 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
U = Voltage of battery pack
n = No load speed
0
T = Adjustable depth of cut (90°)
90°
T = Adjustable depth of cut (45°)
45°
A = Adjustable angular cut angle
D = Saw blade diameter
d = Saw blade drill diameter
a = Max. base body thickness of saw
blade
b = Cutting width of saw disc
c = Thickness of splitting wedge
m = weight
a = Typical estimated acceleration in the
hw
hand/arm area
Typical A-effective perceived sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
During operation the noise level can exceed
85 dB(A).
Wear ear muffs!
Measured values established according to
EN 60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
ENGLISH
ENG
15