KitchenAid ARCHITECT II Série Guide D'utilisation Et D'entretien page 24

Oven will not operate
Is this the first time the oven has been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
Is the electronic oven control set correctly?
See "Electronic Oven Control" section.
Has a delay start been set? See "More Options" section.
On some models, is the Control Lock set?
See "Locking the Oven Control and Oven Door" section.
On some models, is the Sabbath Mode set? See "Sabbath
Mode" in "Setup" section.
Oven burner flames are yellow or noisy
Is propane gas being used?
The range may have been converted improperly. Contact a
service technician or see "Assistance or Service" section.
Cooling fan runs during baking, broiling or cleaning
It is normal for the fan to automatically run while the oven is in
use and for some time after to cool the electronic control.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See "Temp Adjust" in the "Setup" section.
Display shows messages
Is the display showing "FAULT DETECTED?" A fault has
been detected. Follow the displayed directions "PRESS
ENTER TO TRY AGAIN" or "DISABLE POWER TO CLEAR." If
the fault does not clear, reappears, or "FEATURE NOT
AVAILABLE" is displayed, call for assistance or service.
Is "SAb" flashing?
Oven is in Sabbath Mode. To cancel, press and hold the
SETUP pad for 5 seconds.
Self-Cleaning cycle will not operate
Is the oven door open?
The display will show "door." Close the oven door all the way.
Has the function been entered?
See "Self-Cleaning Cycle" section.
On some models, has a delay start Self-Clean cycle
been set?
See "Self-Cleaning Cycle" section.
Has a delay start been set?
See "More Options" section.
Is the control in Sabbath Mode? See "Sabbath Mode" in
the "Setup" section.
Is the oven temperature above 400°F (205°C)?
Let the oven cool before using the self-clean cycle.
24
Oven cooking results not what expected
Is the range level?
Level the range. See the Installation Instructions.
Is the proper temperature set?
Double-check the recipe in a reliable cookbook.
Is the proper oven temperature calibration set?
See "Temp Adjust" in the "Setup" section.
Was the oven preheated?
See "Baking" section.
Is the proper bakeware being used?
See "Bakeware" section.
Are the racks positioned properly?
See "Positioning Racks and Bakeware" section.
Is there proper air circulation around bakeware?
See "Positioning Racks and Bakeware" section.
Is the batter evenly distributed in the pan?
Check that batter is level in the pan.
Is the proper length of time being used?
Adjust cooking time.
Has the oven door been opened while cooking?
Oven peeking releases oven heat and can result in longer
cooking times.
Are baked items too brown on the bottom?
Move rack to higher position in the oven.
Are pie crust edges browning early?
Use aluminum foil to cover the edge of the crust and/or
reduce baking temperature.
Broiling results not what expected
Is there excessive smoking? Food may be too close to the
broil element or may have excessive fat. Move rack to a lower
position.
Is the oven door closed? Close oven door to the broil stop
position.
Was the broil element preheated? Allow broil element to
preheat for 5 minutes.