KitchenAid ARCHITECT II Série Guide D'utilisation Et D'entretien page 11

Masquer les pouces Voir aussi pour ARCHITECT II Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MANUAL sets the oven to Sabbath Mode for 72 hours.
"SABBATH" and "SABBATH ENABLE" appear in the display
for 5 minutes. If Bake or Cook/Hold Bake are desired during
Sabbath Mode, they must be programmed during this
5-minute time before the MANUAL Sabbath Mode is active.
4. Select ON or OFF.
5. Press SETUP to exit the Setup menu.
To cancel Sabbath mode:
1. Press CANCEL.
2. Press and hold SETUP for 5 seconds.
Temp Adjust
Oven temperatures are tested at the factory. It is normal to notice
some baking time or browning differences between a new oven
and an old one. As ovens get older, the oven temperature can
shift.
You may adjust the oven temperature if you think the oven is not
baking or browning correctly. To decide how much to change the
temperature, set the oven temperature 25°F higher or lower than
the temperature in your recipes, then bake. The results of the first
bake should give you an idea of how much to adjust the
temperature.
To adjust the oven temperature:
1. Press SETUP.
2. Use the arrow to scroll to select TEMP ADJUST.
3. Enter the desired temperature change using the number
pads.
4. Select "+/-" to indicate an increase or decrease in
temperature. The temperature change is displayed at the top
of the window.
5. Press ENTER or wait 3 seconds to accept the change.
6. Press SETUP to exit the menu.
The oven temperature does not need to be readjusted if there is a
power failure or interruption.
Broiling and cleaning temperatures cannot be adjusted.
Tones (beeps)
The number of beeps heard at the end of cooking and at the end
of timer operation and their volume can be adjusted.
To change the beeps at the end of cooking:
1. Press SETUP.
2. Use the arrow to scroll to select TONES.
3. Use the arrow to scroll to select COOK TONE.
4. Use the arrow to scroll and select:
1-30 MIN to hear 1 beep every 30 seconds.
OR
1-60 MIN to hear 1 beep every 60 seconds.
OR
1 BEEP to hear 1 beep only at the end of cooking.
5. Press SETUP to exit.
To change the timer beeps:
1. Press SETUP.
2. Use the arrow to scroll to select TONES.
3. Use the arrow to scroll to select TIMERS TONES.
4. Use the arrow to scroll and select:
2-30 SEC to hear 2 beeps every 30 seconds.
OR
2-60 SEC to hear 2 beeps every 60 seconds.
OR
1 BEEP to hear 1 beep only at the end of the set time.
5. Press SETUP to exit.
To change the volume of the beeps:
1. Press SETUP.
2. Use the arrow to scroll to select TONES.
3. Use the arrow to scroll to select VOLUME.
4. Use the arrow to scroll and select:
HIGH for the highest volume.
OR
MEDIUM for medium volume.
OR
LOW for the lowest volume.
5. Press SETUP to exit.
12 HR Shutoff
The oven will automatically turn off at the end of 12 hours if you
unintentionally leave it on.
To turn off this feature:
1. Press SETUP.
2. Use the arrow to scroll to select 12HR SHUTOFF.
3. Select ON or OFF using the Quickset pads.
4. Press SETUP to exit.
Energy Saver
To save energy, the display can be set to go dark if it is not being
used.
To set the Energy Saver feature:
1. Press SETUP.
2. Use the arrow to scroll to select ENERGY SAVER.
3. Select ON or OFF using the Quickset pads.
4. Press SETUP to exit.
Press any pad to "wake up" the display.
Service
This area of the oven control displays the KitchenAid Customer
Service toll-free phone number.
1. Press SETUP.
2. Use the arrow to scroll to select SERVICE.
3. Press SETUP to exit.
Demo
When Demo is selected, you will see a short presentation
highlighting the features of the range.
1. Press SETUP.
2. Use the arrow to scroll to select DEMO.
3. Select ON or OFF using the Quickset pads.
4. Press SETUP to exit.
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Architect ii kgrk201Architect ii kgrs205

Table des Matières