Getting Ready - Boss GT-001 Mode D'emploi

Masquer les pouces Voir aussi pour GT-001:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
1

Getting Ready

1
Connect the equipment
PHONES jack
OUTPUT jacks
2
Turn on the power
1.
Turn on the [ON/OFF] switch.
2.
Switch on the power of the guitar amp.
MEMO
When connected to a computer, the AC adaptor
is unnecessary because power is supplied by the
computer (p. 11).
* After you've made connections correctly, be sure to turn on
the power in the order of the GT-001 first, and then the
connected system. Powering-on in the incorrect order may
cause malfunctions or damage. When turning the power off,
power-off the connected system first, and then the GT-001.
* This unit is equipped with a protection circuit. A brief interval (a
few seconds) after turning the unit on is required before it will
operate normally.
* Before turning the unit on/off, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/off. However, this is normal
and does not indicate a malfunction.
Convenient tuner function
1.
Press the [TUNER] button.
2.
Play an open string, and tune it so that only the center
indicator in the screen is lit.
3.
When you finish tuning, press the [EXIT] button.
2
Precautions when connecting
* To prevent malfunction and equipment failure, always turn
down the volume, and turn off all the units before making
any connections.
* When connection cables with resistors are used, the
volume level of equipment connected to the inputs (AUX
IN) may be low. If this happens, use connection cables that
do not contain resistors.
* By embedding the AC adaptor cable into the groove on the bottom of the
GT-001, you can prevent the plug from being accidentally disconnected.
DC IN jack
3
GUITAR IN jack
AUX IN jack
Connect an audio
player with a
stereo mini jack
[ON/OFF] switch
[OUTPUT
LEVEL]
knob
Adjust the volume
Adjust the volume with the
[OUTPUT LEVEL] knob.
* The volume of an audio player connected to
the AUX IN jack should be adjusted using its
own volume controller.
[EXIT] button
[TUNER] button

Publicité

Table des Matières
loading

Table des Matières