Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
2
LEVELLING THE BATHTUB
Place the bathtub in the prepared installation area and
proceed to level it, adjusting the perimeter feet followed
by the central feet until all are firmly level on the floor.
In order to ensure proper ventilation of the whirlpool
system, when making adjustments leave a minimum
distance of 15 mm between the floor and the bottom
edge of the bathtub panel.
3
ELECTRICAL CONNECTIONS (tubs with whirlpool)
See the Installation Standards manual attached .
Before making any electrical connections, check that the rated voltage and current of the appliance (see data plate)
are matched to the mains power supply.
Connect the taps to terminal S (equipotential bonding point) with the Yellow-Green wire.
Use terminal S for the connection of any external wires that need to be equipotentially bonded.
Connect the alarm
6
- only if the bathroom is equipped with an alarm system.
Alarm
connection
NA
Publicité
Table des Matières
