Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
2x
2x
Reassemble the panels, starting with the side ones (in the case of bathtubs with 2 or 3 panels) and then the front panel.
Place the panel next to the bathtub when assembling; press the upper edge of the panel so that it fits between the springs
(M) and the bathtub rim. Press the panel on its bottom until it is laid on the check angle bracket that we have previously
fastened to the ground. While holding the panel firm in this position, loosen off the supports so that they fall down to ground.
Before fastening the front panel supports (in case of a bathtub with 2 or 3 panels), secure the front panel to the side ones,
applying leverage with a hand or use a screwdriver to force the lever that is on the side panels, thereby facilitating their
slotting in.
14
300 mm
300 mm
2
1
Publicité
Table des Matières
