Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
If fastening the panels with screws, place the angle bracket on ground positioned accordingly to the mark with the base
facing outward, not in the direction of the bathtub and always allowing a distance of 300 mm from the wall in the case of a
bracket for the side panel. Holding it in place with your hand, use the other to trace the posiiton of the hole on the floor with
a pencil. Move the bracket, drill the holes in the marked spots using a drilling machine and fit in the plug. Reassemble the
bracket and tighten the screws.
The diagram below summarizes the number of angle brackets and their position with reference to the number of panels.
=
=
160 mm
160 mm
3x
50 mm
=
=
3x
50 mm
13
Publicité
Table des Matières
