Gima ECG90A Manuel D'utilisation page 26

Chapter 7 Operation Instructions and Parameter Setting
7.1 Main Menu
【Operating instructions】
1. Enter corresponding setting interface by touch screen.
2.Use "Up""Down""Left""Right" to move the focus to the wanted submenu and press confirm
key or touch
3.Click or press return key to return the sample interface.
7.2 Sample Interface
The interface is shown as Fig.7-2.
【Function introduction】
This interface shows waveform. You can modify gain, speed, print mode, waveform display
mode (3-lead, 6-lead, 12-lead), in addition print, set filter quickly, check sate of SD-card.
Operating instructions are as follows:
HR
Selected
to enter corresponding interface.
filter quick setup
Lead information
Tim
e
unselected
Fig. 7-1
State of USB
State of SD
Fig. 7-2
20
State of Battery
Wave area
Buttons