TFK Twinner Lite Notice D'utilisation page 10

- (Fig.IX) Insert the belly bar from above into the frame tubes. Secure
it by moving the clamping lever (17). By pressing the red buttons (18)
at the left and right side you can swivel it to different positions.
- (Fig.X) You can set the height of the push bar by pressing the two
adjustment joints (23).
- (Fig.XI) The handbrake is a walking and parking brake at the same
time. To activate the parking brake, you must pull the brake lever
(20) fully tight and completely close the red parking lever (21), so
that the brake lever (20) remains tightened to the maximum and the
brake is permanently blocked. If the braking effect starts to weaken,
you can carry out a fine adjustment. To do so, turn the adjusting
screw (22) on the brake grip anti-clockwise and check the braking
effect again.
- (Fig.XII) To close the Twinner lite, you must push both locks (23)
upwards. They remain automatically open. Then you can move the
push bar (24) in forward direction. The frame construction
automatically closes.
- (Fig.XIII) Close the transport lock (25) on the frame to ensure that
the Joggster light does not accidentally open up again.
- (Fig.XIV) If you are using the Twinner Lite in cross-country terrain,
please fasten the enclosed retention strap on the rear axle. Then pull
the side with the elastic band over your wrist.