Monogram ZIR301NPNII Instructions D'installation page 69

Installation Instructions - Custom Overlay Door Panel
STEP 6 INSTALL DOOR TRIMS (cont.)
Without touching the exposed tape to the side of the
door, align the top of the trim
with the top of the door panel.
(tape backer should be sticking
out when aligning the trim).
Once the trim is
location (aligned to the top
the door, hinge covers, tight
to the door and door panel),
then push on the exposed tape
area to secure. Slowly start
pulling the tape backer off and
pushing to adhere the tape
while keeping the trim in place
until you have completely
removed the tape backing.
Secure the top and bottom
portions of the outer trim
after the inner trim has been
secured.
31-1000600 Rev. 1
1. Gently pull the top of the outer trim away from the
door panel in order to expose the tape backer. Do not
bend too far away from the door or trim damage may
occur.
2. Peel the backer off the outer trim tape and press to
in secure the trim.
of
3. Repeat for the bottom of the outer trim.
Once the handle side door trim is in place, repeat the
same steps for the hinge side door trim.
69