Télécharger Imprimer la page

Monogram ZIR301NPNII Instructions D'installation page 66

Masquer les pouces Voir aussi pour ZIR301NPNII:

Publicité

Les langues disponibles

Les langues disponibles

Installation Instructions - Custom Overlay Door Panel
STEP 2 INSTALL OVERLAY PANEL
Remove bottom hinge cover and retain the 4 T30
Torx screws for later installation.
Bottom
Hinge
Cover
Open door to 90°. Slide the
panel onto the door with the
panel brackets interlocking
on top and bottom with the
door brackets (make sure
not to slide the panel into the
cabinetry surround). Center
the panel on the door, then
slowly close the door while
watching to make sure
the panel does not contact the
surrounding cabinetry.
With the door fully closed,
carefully slide the panel towards
the cabinetry with the goal gap
of 1/8".
STEP 3 ADJUST OVERLAY PANEL
Door adjustments will
be made with 12 set
screws provided. Each
corner of the door will
use 3 adjustment set
screws. Use a 1/8" allen
wrench to install the set
screws in the order as
instructed.
The set screws behind
the top and bottom
support brackets are
partially hidden.
T30 Torx
Screws
Panel
Bracket
Panel
Door
Bracket
Overlay
Cabintery
Panel
Surround
1/8" gap
Set
Screws
Hidden Set
Screw
Set
Screws
STEP 3 ADJUST OVERLAY PANEL
(Cont.)
Follow the next steps for set screw installation.
For flush mounting, inspect the gap between the
panel and cabinetry at the handle side.
If the gap at the top is too large or uneven use the
set screws on the top bracket to adjust the gap until
the gap is equal along the entire vertical section.
Inspect the alignment at the top of the panel.
Adjustments can be made by turning the vertical
adjustment screws, equally, on the top of the panel
bracket (2 adjustment screws per panel).
Vertical adjustment screw locations.
If the panels do not lay flat, they can be adjusted.
Start by adjusting the top corners and then moving
to the bottom corners. Each corner can be adjusted
independently.
If the panel is too deep inside the
cabinetry, the panel needs to move
away from the unit. Install the
outermost horizontal screws in all 4
corners and screw in until panel is
in position.
If the panel is too proud of the
surrounding cabinetry,
needs to move toward the unit.
Install the innermost horizontal
screws in all 4 corners and screw in
place until the panel
66
the panel
is in position.
31-1000600 Rev. 1

Publicité

loading