Lotus FT-74ET Serie Instructions Pour L'installation Et L'emploi page 21

Installation must be carried out observing the following norms:
- Safety prescription in force
- Installation prescription, ECI norms.
The appliance is supplied without the electric connection cable. To install the power supply cable, proceed as follows:
•
Disconnect the power supply.
•
Remove the front panel
•
Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in
the junction box and fix them into place.
•
Block the cable with the cable blocker, and reassemble the front panel. The earth wire must be longer than the
others so that if the cable blocker should break, it will disconnect after the tension wires.
N.B. The connection cable must have the following characteristics: it must be at least the silicone type (resistant to a
temperature of at least 180°C, and must have an adequate section for the power of the appliance (see technical data
table).
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Attention! Use the appliance only under surveillance.
With fry-top appliances, meat, fish, eggs, vegetables, cheese, etc. can be cooked.
INSTRUCTION FOR USE GLASS CERAMIC
Warning:
Never leave the working appliances unattended!
-Keep in mind that during use of the glass ceramic top the temperature of the glass surface increases considerably and
therefore act accordingly
Indications
The appliance is equipped with a temperature limiting device that acts when the temperature reached can damage the
glass
Warning
Prevent the glass from being hit, above all by objects with corners and points.
Be careful never to cover the glass with sheets of aluminium paper or similar material during use.
Fry tops are appliances for cooking meat, fish, eggs, vegetables, cheese, etc.
Check that the drip pan is inserted. Switch on the switch situated above the appliance. In models FT-78ET and FT-
712ET, it is possible to use one half of the hotplate or to make the two halves work at different temperatures. Turn the
knob from "O" into the desired position between 50° and 300°; The white and green lights come on.
The green light indicates the presence of electrical tension.
The white light shows that the heating element is working; when the temperature is reached, it goes out. To turn off the
appliance, turn the knob into position "O".
Before using the appliance for the first cooking, it is necessary to clean it carefully (see paragraph "cleaning and care").
GB
LAWS, TECHNICAL RULES AND NORMS
ELECTRIC CONNECTION
EQUIPOTENTIAL
symbol.
INSTRUCTIONS FOR USE
TURNING ON
STARTING UP
IE
21