Publicité
Les langues disponibles
Les langues disponibles
• If you are installing your refrigerator next to a fixed wall, leave
sufficient space on the hinge side to allow for the door to swing
open.
• Never install your refrigerator near heat source and direction to
shine.
ELECTRICAL REQUIREMENT
WARNING:
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or
electrical shock. Before you move your refrigerator into its
final location, it is important to make sure you have the proper
electrical connection.
RECOMMENDED EARTHING METHOD
A 220~240 Volt /50 Hz AC only 10 ampere fused and properly
earthed electrical supply is required. It is recommended that a
separate circuit serving only this appliance be provided.Use a
receptacle which cannot be turned off with a switch or pull chain.
Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the refrigerator control to OFF and
then disconnect the refrigerator from the electrical source. When
you are finished, connect the refrigerator to the electrical source
and reset the control to the desired setting.
LEVELING
If the refrigerator is not leveled during installation. The doors
may not close or seal properly, causing cooling, frost, or moisture
problems. It is very important of the refrigerator to be level in
order to function properly.
To level your refrigerator, you may either turn the level leg
clockwise to raise that side to the refrigerator or turn counter –
clockwise to lower that side.
NOTE: Having someone push against the top of the refrigerator
take some weight off the leveling leg. This makes it easier to
adjust the leveling leg.
DO NOT REMOVE GROUND PRONG.
-34-
Publicité
