Publicité
Les langues disponibles
Les langues disponibles
3. INSTALLING YOUR REFRIGERATOR
User should take out the door handle in the plastic bag, and
install it into the door. Then take out the two handle stopples and
cover the installed screws with them. The handle stopple and
screw stopple in the plastic bag can be used when the user wants
the door to be opened from left.
UNPACKING YOUR REFRIGERATOR
WARNING:
Failure to do so can result in back or other injury.
• Remove tape and any labels from your refrigerator before
using(except the rating label).
To remove any remaining tape or glue, rub the area briskly with
your thumb.
Tape or glue residue can also be easily removed by rubbing a
small amount of liquid dish soap over the adhesive with your
fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol flammable fluids,
or abrasive cleaners to remove tape or glue. These products can
damage the surface of your refrigerator.
• When moving the refrigerator, do not tilt the refrigerator beyond
45°from upright position.
CLEANING BEFORE USE
After you remove all of the packaging materials, (in particular,
the foam between the outside condenser and cabinet should be
taken off) clean the inside of your refrigerator before using it.
SPACE REQUIREMENTS
WARNING:
gasoline, away form refrigerator. Failure to do so can result in
death, explosion, fine or burns.
• To ensure proper ventilation for your refrigerator, allow for
200mm space on each side between walls, 100mm space
between back of your refrigerator and the wall, and 300mm
space between counter top and the roof or ceiling.
Use two or more people to move refrigerator.
Keep flammable materials and vapors, such as
-33-
Publicité
