DS Produkte JS-028 Mode D'emploi page 19

19
2. Screw the feet (6 + 7) onto the bottom of the
frame. Do this by using the corresponding
bolts (in each case 2 x truss head bolt M10),
washers (2 x Ø 10mm in each case) and
self-locking nuts (2 x M10 in each case).
Make sure that the feet are placed in the correct
position! The self-locking nuts must not be at-
tached from below as otherwise the device is not
able to stand securely on the fl oor.
3. Fold out the foot pedals (5 + 9). You should feel
and hear them click into place. The locking pin
must protrude out of the recess and sit below the
joint (see picture).
4. Fold up the right pedal linkage (9) and screw the
impact protection bolt (E) into the frame. Then
also fold up the left pedal linkage (4) and also
insert and tighten the impact protection bolt on
the other side of the frame.
5. Place the storage basket (11) on the rear of the
frame and screw it on tight. Do this using 2 x
cross-head bolts M4 (A).
6. Place the holding bar (2) on the top of the frame
and screw it tight using 2 x hexagon socket bolts
M8 (B) and 2 x Ø 8 mm washers (C).
EN