Publicité
Les langues disponibles
Les langues disponibles
Kitchen timer
You can use the kitchen timer to set a time of up to 99 minutes.
It runs independently of all the other settings.
Setting the kitchen timer
No hotplate should have been selected.
Touch the
symbol,
3
‹‹
1.
Set the required cooking time using the twist knob.
2.
Keep warm function
The keep warm function is suitable for melting chocolate or
butter and for warming food and cookware.
Switching on the keep warm function:
Select the hotplate using the twist knob.
1.
In the next 5 seconds, touch the L symbol.
2.
Wipe protection
If you wipe over the control panel while the hob is switched on,
settings may be altered.
To prevent this from happening, your hob has a wipe protection
function. Touch the
symbol. A signal sounds. The control
"
Automatic time limit
If a hotplate is in use for a long time without the setting being
changed, the automatic time limit is activated.
The hotplate stops heating.
hotplate indicator.
Basic settings
Your appliance has various basic settings. You can adapt these
settings to your needs.
Indicator
Function
Automatic childproof lock
™‚
Switched off.*
‹
‚
Switched on.
Audible signal
™ƒ
‹
Confirmation signal and fault notification switched off.
Only fault notification switched on.
‚
ƒ
Confirmation signal and fault notification switched on.*
Automatic timer
™†
Switched off.*
‹
-
Cooking time, after which the hotplates switch off
‚
ŠŠ
*Basic setting
lights up in the timer display.
and
flash alternately in the
"
‰
The timer starts counting down after a few seconds.
When the cooking time has elapsed
A signal sounds for one minute and
display. The
V
indicator flashes. Touch any control. The
indicators go out and the audible signal ceases.
Changing the time
Touch the
3
symbol and use the twist knob to change the
time.
appears in the heat setting display. The keep warm function
–
is switched on.
Switching off the keep warm function:
Select the hotplate and touch the L symbol.
heat setting display.
After approximately 5 seconds, the hotplate is switched off, and
the residual heat indicator appears.
panel is locked for 30 seconds. You can now wipe over the
control panel without altering any settings.
Note: The main switch is excluded from the wipe protection
function. You can switch off the hob at any time.
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
‹‹
lights up in the timer
‹
appears in the
27
Publicité
