DENTAURUM SUS2 Mode D'emploi page 18

4. Setting and activating the SUS
One or a combination of the following steps can be taken
to ensure that the SUS
2
The SUS as a spring: The SUS
2
additional force of approx. 3.0 N, is available if greater
activation is required. The turbo spring is placed on the
SUS telescope element so that the three closed coils are
2
pointing towards the SUS
SUS as a hinge: Standard activation is completed
2
using the 1 mm and 2 mm spacer rings supplied
(REF 607-103-11 and 607-104-11). Depending on
requirements, one or several spacer rings can be clamped
on the SUS telescope rod using special crimping
2
pliers (REF 003-710-00) or Weingart universal pliers
(REF 003-120-00) (Fig. 11).
Caution: Only use the SUS
soldered appliances that are retained using bands –
the appliance can only be activated using spacer rings
(no SUS turbo spring).
2
18
2
meets individual requirements:
turbo spring, with an
2
telescope rod (Fig. 10).
2
as a hinge on cast or
2
Fig. 10 Additional activation when using
as a spring.
Fig. 11 Additional activation when using
as a hinge.