Assembly - Tunturi T30 Mode D'emploi

ASSEMBLY

As for the assembly of the device, we recommend two
grown-up persons. Do not take the treadmill out of the
box: use the packing material to cover the fl oor on the
assembly site.
Before assembling the device, insure all parts are present:
1. Frame
2. Power cord
3. Assembly kit (contents are marked with an * in the spare
part list): keep the assembly tools, as you may need them
e.g. for adjusting the equipment.
In case of problems contact your Tunturi dealer.
The directions left, right, front and back are defi ned
as seen from the exercising position. To avoid
injury, you must fold up the deck prior to lifting the
treadmill out of the box.
Locate the hardware bag and parts that are listed in
the chart below.
Lift up the upright, then place the screws (A) and
washers (B, C) inside holes at the bottom of the
upright. Use the screwdriver (F) to tighten them
well.
Put the console to the correct position. Use the allen
key (E) to tighten the screws (A) and washers (B)
inside holes at the top of the upright.
Attach side cap (H) with the screws (D) at the bottom
of the upright, and tighten them well.
3
ENGLISH
T30 - OWNER'S MANUAL