Télécharger Imprimer la page

Progress PKT1441 Notice D'utilisation page 25

Masquer les pouces Voir aussi pour PKT1441:

Publicité

Les langues disponibles

Les langues disponibles

Problem
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
Water flows inside the refrig‐
erator.
Possible cause
The mains plug is not con‐
nected to the mains sock‐
et correctly.
There is no voltage in the
mains socket.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the ap‐
pliance is too low and the
ambient temperature is
too high.
Temperature is set incor‐
rectly.
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
Progress 25
Solution
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation".
Wait few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Refer to "Closing the door".
Set a higher temperature. Re‐
fer to "Operation".
Set a higher temperature. Re‐
fer to "Operation"
Refer to "Operation" .
Make sure that food products
do not touch the rear plate.
Clean the water outlet.

Publicité

loading