Publicité
Les langues disponibles
Les langues disponibles
3.
Select desired spray tip:
•
For gentle rinse, select white 40° spray tip.
•
To scour surface, select yellow 15° or red 0° spray
tip.
•
To apply chemical, select black spray tip.
4.
Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
5.
For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface.
6.
DO NOT get closer than 6 inches when cleaning tires.
Cleaning and Applying Detergent
IMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could
damage the pump.
CAUTION
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
1.
Review spray tip use.
2.
Prepare detergent solution as required by
manufacturer.
OPERATION
3.
Place small filter end of detergent siphoning tube into
detergent container.
Keep the detergent siphoning tube from coming in
contact with the hot muffler.
• When inserting the filter into a detergent solution bottle,
route the tube so as to keep it from inadvertently contacting
the hot muffler.
4.
Make sure black cleaning detergent nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure spray tips (White,Yellow or Red).
5.
Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump and start engine.
6.
Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
7.
Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
IMPORTANT:You must flush the injection system after
each use by placing the filter into a bucket of clean water,
then run the pressure washer in low pressure for
1-2 minutes.
13
CAUTION
Publicité
