Publicité
Les langues disponibles
Les langues disponibles
Adjustments and Settings Using the Menu
B
Using the MENU
The projector is equipped with an on-screen
menu for making various adjustments and
settings. You can change the menu language
displayed in the on-screen menu.
To change the menu language, see
"Selecting the Menu Language" on page 20.
1
Press the MENU key.
The menu appears.
The menu presently selected is shown as
a yellow button.
PICTURE CTRL
CONTRAST:
BRIGHT:
GAMMA MODE: GRAPHICS
COLOR TEMP:
2
Use the M or m key to select a menu,
then press the , or ENTER key.
The selected menu appears.
Menus
SET SETTING
STATUS:
INPUT-A:
KEYSTONE MEMORY: ON
DIGITAL KEYSTONE:
LANGUAGE:
INSTALLATION:
POWER SAVING:
SIRCS RECEIVER: FRONT&REAR
LAMP TIMER:
3
Select an item.
Use the M or m key to select the item,
then press the , or ENTER key.
4
Make the setting or adjustment on an
item.
GB
26
Using the MENU
INPUT-A
8 0
5 0
HIGH
Setting items
INPUT-A
ON
RGB
OFF
ENGLISH
FLR-FRONT
OFF
00010h
• When changing the adjustment level:
To increase the number, press the
,
key.
To decrease the number, press the m
or < key.
Press the ENTER key to restore the
original screen.
• When changing the setting:
Press the M or m key to change the
setting.
Press the ENTER or < key to restore
the original screen.
To clear the menu
Press the MENU key.
The menu disappears automatically if a key
is not pressed for one minute.
To reset items that have been
adjusted
Press the RESET key.
"Complete!" appears on the screen and the
settings appearing on the screen are reset
to their factory preset values.
Items that can be reset are:
• "CONTRAST," "BRIGHT," "COLOR,"
"HUE," and "SHARP" in the PICTURE
CTRL menu
• "DOT PHASE," "SIZE," and "SHIFT" in
the INPUT SETTING menu
• "DIGITAL KEYSTONE" in the SET
SETTING menu
About the memory of the settings
The settings are automatically stored in the
projector memory.
If no signal is input
If there is no input signal, "NO INPUT–
Cannot adjust this item." appears on the
screen.
M
or
Publicité
