Melitta LatteSelect F63/0-201 Mode D'emploi page 29

13 Troubleshooting
Contact our hotline if the actions listed
below fail to rectify the problems or if
other problems not listed here occur.
Problem
Co ee only emerges
from the outlet in drips.
Co ee does not ow
through.
Grinder does not grind
co ee beans.
The Re ll beans display
ashes although the
2-chamber bean con-
tainer is full.
Loud grinder noise.
Brewing unit cannot be
inserted after removing.
System error appears on
the display.
Cause
Grinding neness too ne.
Appliance soiled.
Appliance is covered
inside with limescale.
Water tank not lled or
inserted incorrectly.
Brewing unit clogged.
Co ee beans do not drop
into the grinder.
"Bean Select" tilt lever is
positioned vertically.
Co ee beans are too oily.
Foreign object in the
grinder.
Co ee beans do not drop
into the grinder. Insu -
cient ground co ee beans
in the brewing unit.
Foreign object in the
grinder.
Brewing unit is not cor-
rectly locked.
Drive is not in the correct
position.
Software problem.
You will nd the telephone numbers (local
rates) in the lid of the water tank or in the
Service section on our website.
Action
Set a coarser grinding neness (see sec-
ƒ
tion 7.7, page 24).
Clean the brewing unit (see section 8.2,
ƒ
page 25).
Run the Cleaning co ee system programme
ƒ
(see section 8.7, page 26).
Descale the appliance (see section 8.8,
ƒ
page 26).
Fill the water tank and ensure it is
ƒ
positioned correctly (see section 4.1,
page 21).
Clean the brewing unit (see section 8.2,
ƒ
page 25).
Tap lightly on the 2-chamber bean con-
ƒ
tainer.
Clean the 2-chamber bean container.
ƒ
Move the tilt lever to the left or right.
ƒ
Use di erent co ee beans.
ƒ
Contact the hotline.
ƒ
Press direct key.
ƒ
Contact the hotline.
ƒ
Check that the handle for the brewing unit
ƒ
locking mechanism is correctly engaged
(see section 8.2, page 25).
Press and hold the brewing strength
ƒ
button. Also press the "On/O " button for
longer than 2 seconds. Release the buttons
again. The appliance then initialises.
Switch the appliance o and on again.
ƒ
Contact the hotline.
ƒ
Troubleshooting
29