EUROM Sani 400 Manuel D'utilisation page 37

Set-up and operation
Make sure the heater is turned off (On/Off switch to O). Now plug into an correctly
functioning 220-240V / 50Hz socket.
Turn the heater on by pushing the on/off switch to 'on' (I pushed in). The control
light will come on, the display will light up and the ambient temperature will show
on the display.
Manual operation
Pressing on the + or - button will display the set temperature (which will flicker

for a few seconds). You can adjust this a degree higher or lower by pressing the
+ or - button until the desired temperature is set. If the desired temperature is
set higher than the ambient temperature, the heater will start to heat. The
temperature will be maintained as a result of the heater switching itself on and
off.
Pressing the timer button sets a specific time. The set time will flicker for a few

seconds on the temperature display. Every time you press the button, the time
will increase by 1 hour, from 0 hours (0H) to 24 hours. Pressing it again will
reset it to zero.
The LCD-screen will extinguish automaticly after ± 15 seconds. When you touch

the screen between the brackets again, it will light up again.
To switch off, click the ON / OFF-switch to off. The heater switches off. Unplug.
Wi-Fi and app operation
The heater can also be controlled with an app. To do this, the heater must be
connected to a Wi-Fi modem.
If you switch on the heater without a WiFi connection to a smartphone, the WiFi-
connection light will blink. As soon as you make the connection, the light will burn
continuously. Then you can set the temperature and timer using your smartphone.
In principle, you can connect only a single (1) smartphone, unless you share the
connection in the app (share service).
If it is not possible to connect Wi-Fi to the heater, the heater must be reset. You
can reset by pressing the timer button
the WiFi symbol starts flashing alternately on the stove quickly or slowly.
Smart Timer
Besides the usual count-down timer, the app also enables you to set a weekly
schedule using the Smart Timer. If required, this schedule can run continuously.
Download the Eurom Smart App
Scan the QR code below or search for 'Eurom Smart' in the App store or Google
-
Play and follow the download instructions.
on the heater for 5 seconds. After this,
37