EUROM Sani 400 Manuel D'utilisation page 36

Description and Installation
1. Panel
2. Towel rail
3. ON/OFF switch with control light
4. Control panel with LCD-screen
5. Temperature display
6. + Button: 'temperature higher'
7. - Button: 'temperature lower'
8. Timer setting button
9. Wi-fi connection light
Remove all packaging material and keep out
of reach of children. After removing
packaging, check the appliance for damage or
other signs that could indicate a
fault/defect/malfunction. In case of doubt, do
not use the appliance, but contact your vendor
for inspection or replacement.
Slide the towel rail over both sides of the panel,

secure them to rear of the panel with the 4x2 nuts.
Choose a solid, flat and completely vertical wall

made of non-flammable and non-melting material
on which to mount the heater (i.e. no wood,
synthetic materials, etc!)
Select a suitable location for the device taking

into account all the aforementioned warnings
in this manual.
Place the hanging support against the wall, short

side with two brackets at the top, brackets facing
forwards. Now mark the location of the 5 screws.
Make sure that the top two are exactly horizontal!
Drill the 5 holes and insert a plug into each.

Screw the support securely to the wall

Slide both the channels on the panel (at the top on the back) over the brackets

and check to ensure that the heater is horizontal and securely attached.
Secure panel and support using the nut underneath by screwing the support to

the panel.
Your heater is now ready for use.

36