Worx WX531 Mode D'emploi page 16

according to EN 60745:
Vibration
emission value:
The declared vibration total value may be used for
comparing one tool with another, and may also be used
in a preliminary assessment of exposure.
WARNING: The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
16
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
WARNING: Do not release the handle until the saw blade
come to complete stop and do not touch saw blade while
the saw blade is running.
Intended use: The tool is intended for ripping and cross-
cutting wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
ACTION
20V Cordless Brushless Circular saw
2
Cutting tile: a =0.466m/s
h
Uncertainty K = 1.5m/s2
FIGURE
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Mounting and Removing the
Blade
NOTE: Lock or loose the blade
bolt, the spindle lock button
should be pressed.
WARNING: Always remove
the battery before changing
the blade!
Safety switch and On/Off trigger
WARNING: To avoid cutting
injury from the sharp blade,
please don't put your hands
around the Base Plate.
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Rip and Cross Cutting
NOTE: The cutting line of saw
blade is aligned with the cutting
mark 0°.
Parallel Guide
Adjusting the Cutting Depth
Adjusting the Cutting Angle
NOTE: The cutting line of saw
blade is aligned with the cutting
mark 45°.
Pocket /Plunge
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting
with extreme force can significantly reduces the
performance capability of the tool and reduces the
service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition and
the tooth count of the saw blade. Therefore, use only
sharp saw blades that are suited for the material being
cut.
Choice of blades: 24 teeth for general work, approx. 40
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
See Fig. C
See Fig. D1, D2
See Fig. E1, E2
See Fig. F1, F2
See Fig. G
See Fig. H1, H2
See Fig. I
EN