Worx WX531 Mode D'emploi page 15

***Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage is
18 volts.
Category
WA3550.1
20V Battery
WA3551.1
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
NOISE INFORMATION
(CUTTING WOOD/CUTTING
METAL)
A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection
NOISE INFORMATION
(CUTTING TILE)
A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection
VIBRATION INFORMATION
CUTTING WOOD/CUTTING
20V Cordless Brushless Circular saw
Type Capacity
WA3550 1.5Ah
1.5Ah
WA3551 2.0Ah
2.0Ah
WA3553 4.0Ah
WA3880 2.0A
WA3760 0.4A
WA3869 2.0A
L = 81.2dB(A)
pA
L = 92.2dB(A)
wA
3dB(A)
L = 88.5dB(A)
pA
L = 99.5dB(A)
wA
3dB(A)
METAL)
Vibration total values (triax vector sum) determined
according to EN 62841:
Cutting wood:a
Uncertainty K = 1.5m/s2
Vibration emission
value:
Cutting metal: a
Uncertainty K = 1.5m/s2
The declared vibration total value and the declared noise
emission value have been measured in accordance with
a standard test method and may be used for comparing
one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from
the declared value depending on the ways in which the
tool is used especially what kind of workpiece is
processed dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
VIBRATION INFORMATION
(CUTTING TILE)
Vibration total values (triax vector sum) determined
= 0.469m/s
2
h,W
2
= 0.455m/s
h,M
15
EN