Preparations; Installing/ Removing The Battery Pack - Kenwood WD-K10PBS Guide De L'utilisateur

INSTALLING/ REMOVING THE BATTERY PACK

This unit comes with the battery pack already installed in it. To
replace the battery pack, follow the steps below to remove and
install the battery pack.
1 Remove the screws (x6) on the rear of the unit and remove
the rear cover.
2 Take out the battery pack and remove the battery connector.
When removing the connector, hold the base of the connector and
pull it straight up slowly.
3 Connect the battery connector to the connector of the unit.

PREPARATIONS

Connector
Connector
11