Precautions - Kenwood WD-K10PBS Guide De L'utilisateur

Do not charge the transceiver and battery pack when they are wet.
●
Ensure that there are no metallic items located between the transceiver
●
and the battery pack.
Do not use options not specified by KENWOOD.
●
If the die-cast chassis or other transceiver part is damaged, do not
●
touch the damaged parts.
If a headset or headphone is connected to the transceiver, reduce the
●
transceiver volume. Pay attention to the volume level when turning the
squelch off.
Do not place the microphone cable around your neck while near
●
machinery that may catch the cable.
Do not place the transceiver on unstable surfaces.
●
Ensure that the end of the antenna does not touch your eyes.
●
When the transceiver is used for long transmissions, the radiator and
●
chassis will become hot. Do not touch these locations when replacing
the battery pack.
Always switch the transceiver power off before installing optional
●
accessories.
The charger is the device that disconnects the unit from the AC mains
●
line. The AC plug should be readily accessible.
WARNING
Turn the transceiver power off in the following locations:
Near explosives or blasting sites.
●
In aircrafts. (Any use of the transceiver must follow the instructions
●
and regulations provided by the airline crew.)
Where restrictions or warnings are posted regarding the use of
●
radio devices, including but not limited to medical facilities.
Near persons wearing pacemakers.
●
In explosive atmospheres (inflammable gas, dust particles, metallic
●
powders, grain powders, etc.).
While taking on fuel or while parked at gasoline service stations.
●

PRECAUTIONS

3