Magmaweld ID 400E Manuel D'utilisation page 19

ID 400E
4.2 Error Codes
Error Code Error
Thermal
ERR-T1
Power Module
E02
Mains Voltage
E04
Mains Voltage
E08
www.magmaweld.com
• Machine is overheated because of
high ambient temperature of
Error
exceeding duty cycle
• Error/Errors may exist in any
Error electronic card
• Mains voltage may have increased
High
• Mains voltage may have decreased
Low
• Let the machine on for a while in
Cause
• Switch off and switch on. If the
• Check the mains connection cables
• Check the mains connection cables
Maintenance and Service
Solution
order to cool down itself with the
cooling fan. After is cools enough,
you can go on welding
error still exists, check the mains
voltage whether it is within the
range of 340V-420V or not. If the
error still exists, contact the
authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
USER MANUAL
19
EN